Motor operated metering pumps are unique in that each outlet/feed is an individual positive displacement pump. These pumps are ideal for dispensing precise easily adjustable volumes of a variety of fluids including: oils or grease for lubrication, inks, dyes, chemical additives and cutting fluids.
The factory should be consulted before using with high water base fluids.
The motor operated metering pumps are:
- Positive displacement, self priming with up to 27 InHg (686mmHg)
- Will operate in any position.
- Are available in 1 to 4 pumps with each pump independently and externally adjustable from 0 to .01 cu. in. (0 to .20 cu. cm.) by a micrometer thread .02 (.57mm) pitch.
- Each pump will actuate once per minute of motor run time. The motor operated metering pumps are intended for lower output pressure applications or where a compressed air supply is not available.
- Oil applications should use R100 series filtered reservoirs.
- Grease applications should use GCA100 or GCA200, GR75 or GR168 Grease Reservoirs.
Standard Features:
- 1/8 inch NPTF stud end
- 120V, 60Hz, 4W
Standard Materials:
- Aluminum, Brass, Steel, Acrylic
- Buna N & Viton seals
Caution:
- For grease applications, the combination of higher viscosities, ambient temperatures lower than 32°F(0°C), excessively long runs of output feed lines, along with the type and use of smaller inside diameter feed lines, will have an effect on the feed rate and output capabilities of these pumps.