PMP400 Series - Electric Panel Mount Systems

These “quick install” cost effective Centralized Lubrication Systems are pre-assembled with compatible components to minimize specification, purchasing and installation time. The automatic lubrication systems operate on a 120V, 60Hz 1Ph electrical supply for the motor. The systems are sized to meet most lubrication requirements where a compressed air supply is not available. Each feed pump is independently and externally adjustable 0 to .01 cu in (0 to .20 cu cm) by using a fine micrometer thread .02 (.57mm) pitch adjustment. Each feed pump will actuate once per minute of motor run time.

Standard Features:

• 1/8 inch NPTF stud end

Standard Materials:

• Aluminum, Brass, Steel, transparent polymer
• Buna N & Viton seals
• Nema compliant panels

Caution:

• For grease applications, the combination of higher viscosities, ambient temperatures lower than 32°F(0°C), excessively long runs of output feed lines, along with the type and use of smaller inside diameter feed lines, will have an effect on the feed rate and output capabilities of these pumps.